Welcome visitor you can login or create an account.
Facebook
Search
Shopping Cart
0 item(s) - $0.00
Your shopping cart is empty!

Track Claw Tire Strengthener (Gallon)

Track Claw Tire Strengthener  (Gallon)
Brand: Track Claw
Product Code: 2995
Availability: In Stock
Price: $86.39
Qty:     - OR -   Add to Wish List
Add to Compare

TRACK CLAW® TIRE STRENGTHENER is designed to strengthen and vulcanize the rubber of the tire by becoming part of it which will add more elasticity and strength to the rubber that significantly increases traction. Unlike other tire treatments TRACK CLAW® TIRE STRENGTHENER is designed to give tires tremendous abrasion resistant properties which will keep tires cooler, decrease wear significantly, and keep tires consistent lap after lap

TRACKCLAW WRAPPING TECHNIQUE

THIS PROCESS INSURES MAXIMUM PENETRATION INTO THE TIRES AND ALSO ELIMINATES ANY GLOSSY OR SHINY APPEARANCE.

 

1-                  START WITH SCUFFED TIRES BEFORE TREATING.  IF SCUFFING IS NOT POSSIBLE, TIRES MAY BE WIRE BRUSHED OR SANDED USING VERY COARSE SANDPAPER.  THE PURPOSE OF THIS IS TO REMOVE MOLD RELEASE AGENTS ON NEW TIRES.

2-                  USING ANY BLANKET MATERIAL, CUT OUT 4 STRIPS TO THE WIDTH OF THE TIRE AND ALSO TO THE CIRCUMFERENCE OF THE TIRE ALLOWING ABOUT AN INCH OVERLAP ON THE CIRCUMFERENCE. 

3-                  DOING ONLY  1 TIRE AT A TIME, POUR OUT A SMALL AMOUNT OF THE TRACKCLAW  IN A FLAT OPEN CONTAINER.  WEARING RUBBER GLOVES, TAKE A SMALL 4” SPONGE PAINT ROLLER AND DIP INTO THE SOLUTION AND  SQUEEZE OUT EXCESS.  APPLY A THIN WET COAT TO THE TIRE.  REPEAT THIS PROCESS AT LEAST 2-3 COATS ON THE TIRE. MAKE SURE THE TIRE STAYS WET! 

4-                  ONCE YOU HAVE APPLIED THE LAST COAT OF TRACKCLAW, TO THE WET TIRE, TAKE THE DRY CLOTH STRIPS AND WRAP IT AROUND THE WET TIRE AND TACK THEM IN PLACE WITH A FEW OFFICE STAPLES.  NOW TAKE YOUR PAINT ROLLER AND ROLL ON ENOUGH TRACKCLAW TO WET THE BLANKET MATERIAL. IMMEDIATELY WRAP THE TIRE IN PLASTIC OR SHRINK WRAP. PUT THE TIRE IN A LARGE GARBAGE OR LEAF BAG AND SEAL IT AIRTIGHT. THIS MUST BE DONE IMMEDIATELY BEFORE ANY EVAPORATION OCCURS.

5-                  LEAVE TIRES IN BAGS FOR AT LEAST 24 – 72 HOURS.  FOR MAXIMUM RESULTS WE PREFER TO LEAVE THEM IN THE BAGS FOR AT LEAST 2-3 DAYS, BUT SOMETIMES YOU MIGHT NOT BE ABLE TO DO THIS BECAUSE OF YOUR TIME AND SCHEDULING. 

6-                  AFTER THE TIRES HAVE BEEN IN BAGS FOR THE SUGGESTED TIME, TAKE THE TIRES OUT OF THE BAGS AND UNWRAP THEM.   YOU WILL NOW NEED TO LET THE AIR CURING PROCESS TAKE PLACE BY ALLOWING AT LEAST 24 TO 48 HOURS DRYING TIME BEFORE YOU RACE ON THESE TIRES.  YOU CAN REUSE YOUR BLANKET WRAPS OVER & OVER AGAIN BY QUICKLY PUTTING THEM IN ZIPLOCK BAGS.

7-                  FOR BEST RESULTS, THIS PROCESS SHOULD BE REPEATED EACH WEEK BEFORE EACH RACE. 

 

 

****  OPTIONAL APPLICATION ON INTERIOR OF TIRE  ****

POUR 10 – 12oz OF TRACKCLAW INTO REAR TIRES AND WHILE THE CAR IS UP ON JACKSTANDS. CRANK UP CAR AND LET RUN 3-5 MINUTES TO INSURE COMPLETE DISTRIBUTION THROUGHOUT INTERIOR OF TIRE. FRONT TIRES CAN BE DONE IN SAME MANNER.

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Captcha



Copyright © 2013 Brothers Research Corporation. All Rights Reserved. TRACK CLAW® is a registered trademarks of Brothers Research Corporation.